Turn on your router's guest Wi-Fi network before visitors arrive, give it a separate password, and check its isolation settings. On eero, ASUS and TP-Link Deco systems that run as your main router, guests then get the internet and nothing on your own network. That changes if your mesh runs as an access point behind your provider's gateway, or if a guest wants to cast to your TV.
What each system blocks by default
eero puts guest devices on a separate subnet, and they can't reach devices on the main network. They can't reach each other either. In eero's example, a laptop on the guest network can't play music on a Sonos speaker on either network. Every eero works this way, the eero 6 included.
On the ASUS guest-network interface described here, Access Intranet controls access to the private network. It's off by default, which keeps guests away from a NAS, shared folders and other devices on the private network. Turning it on opens all of them at once, so we'd leave it off.
TP-Link says a Deco in router mode isolates the guest network from the main one automatically. There's no switch to check.
Google's guest network stays separate too, except for devices you pick. Under "Shared devices" in the Google Home app, you can let guests use a streaming device, a smart TV, a speaker or a printer.
Letting guests cast to the TV
Google's help page describes choosing individual shared devices. On a Google Nest Wifi Pro, you can share the living room TV and nothing else.
On eero, a guest device can't reach any other device on either network, so it has nothing to cast to. On ASUS, the switch the help page describes is Access Intranet, and it opens the whole private network. For a short visit, use the TV's own remote and apps instead of opening your private network. Sign out of any guest accounts before they leave.
Access point mode changes the rules
If your mesh runs as an access point behind an internet provider's gateway, the gateway keeps handing out the addresses. ASUS and TP-Link both change the guest network in that setup.
On ASUS, the Access Intranet switch disappears in access point mode, because the router in front then assigns the addresses and holds control. Its help page doesn't say whether guests stay walled off in that mode. We wouldn't count on that guest network to keep a visitor away from a NAS.
A Deco in access point mode adds a switch instead, called "Allow Local Access," on the guest network's Advanced page. Turned on, it lets guests reach your local devices. Make sure it's off. TP-Link says some Deco models don't have the switch yet and will get it in a firmware update.
Range and time limits on ASUS and Deco
On ASUS models using the guest-network interface in this support page, three guest networks are available per band, and only the first set can sync to AiMesh nodes. The other two broadcast from the main router alone, which can leave a guest room at the far end of the house without a signal. Use the first set.
Both makers can switch the guest network off for you. ASUS lets you set an access time, and the network closes when it runs out. Deco's Duration setting offers fixed periods of up to 24 hours, or always on. Its Auto setting turns the network off after about 10 minutes with no devices connected, on models that support it. We'd match the timer to the length of the visit, so the network doesn't stay open after the last guest leaves.





